Wired Equivalent Privacy (WEP) is a security protocol for wireless networks that encrypts transmitted data . It’s easy to configure. Without any security your data can be intercepted without difficulty.

However, WEP was an early attempt to secure wireless networks, and better security is now available such as DES, VPN, and WPA.

WEP has three settings: Off (no security), 64-bit (weak security), 128-bit (a bit better security). WEP is not difficult to crack, and using it reduces performance slightly.

If you run a network with only the default security, where WEP is turned off, any of your neighbors can immediately log on to your network and use your Internet connection.

 •  For wireless devices to communicate, all of them must use the same WEP setting. (40-bit and 64-bit WEP encryption are the same thing — 40-bit devices can communicate with 64-bit devices.)

 •  While there is no extra performance cost to encrypting the longer key, there is a cost to transmitting the extra data over the network. 128-bit security is not much more difficult than 64-bit to crack, so if you are concerned about performance, consider using 64-bit. If you’re very concerned about security, use WPA, which replaces WEP with a protocol that is — given current technology — impossible to crack.

The WEP concept of passphrase is introduced so that you do not have to enter complicated strings for keys by hand. The passphrase you enter is converted into complicated keys. Choose passphrases with the same care you would important passwords.

•  •  With 128-bit encryption, you need to enter a passphrase to generate each key.




•  •  All four keys must be specified, because WEP switches between them to make your traffic more difficult to break.




•  •  All devices within your LAN must use the same passphrases (i.e., the same keys).